InQor DC/DC Converters
 |
|
 | |
| Click on the image to enlarge it (will open a new window) | |
|
1) Pins 1-3, 5-7 are 0.040" (1.02mm) diameter with 0.080"
(2.03 mm) diameter standoff shoulders.
2) Pins 4 and 8 are 0.062" (1.57 mm) diameter with 0.100"
(2.54 mm) diameter standoff shoulders.
3) Recommended pin length is 0.03" (0.76mm) greater
than the PCB thickness.
4) All Pins: Material - Copper Alloy; Finish - Matte Tin over
Nickel plate
5) Undimensioned components shown are for visual
reference only.
6) Weight: 3.02 oz (85.7 g)
7) All dimensions in inches (mm)
Tolerances: x.xx +/-0.02 in. (x.x +/-0.5mm)
x.xxx +/-0.010 in. (x.xx +/-0.25mm)
8) Workmanship: Meets or exceeds IPC-A-610C Class II
9) UL/TUV standards require a clearance greater than 0.04" (1.02mm) between input and output for Basic
insulation. This issue should be considered if any
copper traces are on the top side of the user's board.
Note that the ferrite cores are considered part of the
input/primary circuit.
10) M3 screws used to bolt unit's baseplate to other
surfaces (such as a heatsink) must not exceed
0.100" (2.54 mm) depth below the surface of the
baseplate.
11) Applied torque per screw should not exceed 6in-lb
(0.7 Nm).
12) Baseplate flatness tolerance is 0.004" (.10mm) TIR for
surface.
PIN-OUT
See InQor Converters Pin-Out description