NiQor DC/DC Converters
    Non-isolated brick dc-dc converters
NiQor Series Non-Isolated DC-DC Converters The NiQor® DC/DC converter is a non-isolated buck regulator, which employs synchronous rectification to achieve extremely high conversion efficiency. The NiQor family of converters are used predominately in DPA systems using a front end DC/DC high power brick (48Vin to low voltage bus). The non-isolated NiQor converters are then used at the point of load to create the low voltage outputs required by the design. The wide trim module can be programmed to a variety of output voltages through the use of a single external resistor.
Product Links
Back to Product matrix and Hightlights
Product Part Numbering Convention
 
SIP VERTICAL MOUNT
 
InQor Encased Mechanical Drawing
 
SIP HORIZONTAL MOUNT
 
NiQor SIP Horizontal Mount Mechanical Drawing
 
   NOTES
  1. All pins are 0.025” (0.64mm) +/- 0.003 (0.076mm) square.
  2. All Pins: Material - Copper Alloy Finish - Tin over Nickel plate
  3. Vertical, horizontal, vertical with reverse pins and surface mount options (future) available.
  4. Undimensioned components are shown for visual reference only.
  5. All dimensions in inches (mm) Tolerances: x.xx +/-0.02 in. (x.x +/-0.5mm) x.xxx +/-0.010 in. (x.xx +/-0.25mm)
  6. Weight: 0.30 oz. (9.4 g) typical
  7. Workmanship: Meets or exceeds IPC-A-610C Class II
   PIN-OUT         See NiQor Converters Pin-Out description