Quad Output Non-Isolated DC-DC Converters

Low voltage, quad output, non-isolated DC-DC converters

Quad Output Non-Isolated DC-DC Converters The MCOTS-N Quad Output Non-Isolated DC-DC converter employs synchronous rectification to achieve extremely high conversion efficiency in a quarter brick package.  The module generates three positive output voltages and one negative output voltage.  All four outputs have a wide output trim range creating a high degree of flexibility for the user.
Product Links
Product Matrix
Part Numbering
Encased
 
Quad Output Non-Isolated DC-DC Converters Encased Mechanical Drawing
 NOTES
   1) Applied torque per M3 screw should not exceed 5in-lb. (6in-lb Limit).
       Screw should not exceed 0.100" (2.54mm) depth below the surface of the baseplace.
   2) Baseplate flatness tolerance is 0.004" (.10 mm) TIR for surface.
   3) Pins 1-5 and 13-18 are 0.040" (1.02mm) diameter, with 0.080" (2.03mm) dia. standoff shoulders.
   4) Pins 6-12 are 0.062" (1.57 mm) diameter with 0.100" (2.54 mm) dia. standoff shoulders.
   5) All Pins: Material: Copper Alloy; Finish: Matte Tin over Nickel plate
   6) Alternative pin lengths may be available. Check with factory
   7) Weight: see product datasheet
   8) All dimensions in inches (mm)
       Tolerances:
         x.xx +/-0.02 in. (x.x +/-0.5mm)
         x.xxx +/-0.010 in. (x.xx +/-0.25mm)
 
Flanged
Quad Output Non-Isolated DC-DC Converters Flanged Mechanical Drawing
 
 NOTES
   1) Applied torque per M3 or 4-40 screw 4in-lb Recommended (5in-lb Limit).
   2) Baseplate flatness tolerance is 0.004" (.10 mm) TIR for surface.
   3) Pins 1-5 and 13-18 are 0.040" (1.02mm) diameter, with 0.080" (2.03mm) dia. standoffs.
   4) Pins 6-12 are 0.062" (1.57 mm) diameter with 0.100" (2.54 mm) dia. standoffs.
   5) All Pins: Material: Copper Alloy; Finish: Matte Tin over Nickel plate
   6) Alternative pin lengths may be available. Check with factory
   7) Weight: see product datasheet
   8) All dimensions in inches (mm)
       Tolerances:
         x.xx +/-0.02 in. (x.x +/-0.5mm)
         x.xxx +/-0.010 in. (x.xx +/-0.25mm)